Click Image for more pictures and specifications, and installation instructions.
This is a less common size, F13T5 and similar. This size is common to 12 volt supplies so this includes a 12 DC driver. Check the measurements to ensure this is the correct item for your needs. "21 inch Tubes actually measure slightly shorter, see the dimensions in the spec chart and photos. Tube sizes are standardized, so if you have a T5 that is right around this length, this is the replacement. These install the same as our 12" tubes so the instructions are shared.
This is a LED retrofit light for 21" Florescent Tube Lights. Due to the size of these smaller tube lights, an external driver is provided. This driver converts 10-30v DC RV power to a clean 12v DC power for long tube life. Other brands of retrofit tube lights have a wire and the driver hanging out the side of the tube, we choose to provide the driver separately and we utilize the natural pins on the end of the tube for power for a much cleaner looking installation. Since the driver occupies the space of your previous ballast, you will never see the wires or driver while looking up at your fixture.
6000k Cool White. For 4500k Natural White see part number T5-21Tube-NW. This size is not available in 3200 Warm White.
You will need basic 12vDC wiring skills to install these tubes, or have them professionally installed. Wiring is basic, each driver gets a positive and negative wire connected, and each driver has a positive and negative wire that need to be connected to the end of each tube. View the full detailed installation instructions here Not recommended to be used near HAM radio or in close proximity to sentive radio or tv equipment.
- 9-12vDC Tube Light with a 10-30vDC driver (must be used with included driver)
- Draws only 0.34A at 12.8vDC
- Sold Per Tube, for fixtures with two tubes you will need to order Qty of 2
|Rated Volts||10-30v DC|
|Polarity||Non Polarity Driver|
|Overall Length||20.5 +/- w/o pins, 22 +/- with pins|
|Overall Width (or diameter)||3/4"|