Click Image for more pictures and specifications. Buy 10 per SKU and save 10%.
Now with 30 Brighter Cool White Light 2835 SMD LEDs.
Easy push installation
Standard T10 Wedge base - may ship silver or white Cross References to incandescent bulbs 904, 904NA, 906, 906NA, 912, 916, 916NA, 917, 920, 921, 922, 158, 160, 161, 161B, 168, 168A 168NA, 175, 193, 194, 194B, 194G, 194NA, 194R, 2821, 2825, 2827, 2886X, 3652, 558, 579, 658, W5WB
10-30 Volts Continuous Power No Polarity
Calculated 150 Lumens
Good economical choice. For Visably Brighter bulbs see our bulbs with 5050 SMD LED chips
|Amps at 12.8v DC (Fluke Actual)||0.17|
|Rated Volts||10-30v DC|
|Overall Length||1 3/4"|
|Overall Width (or diameter)||3/4"|
44 Reviews Hide Reviews Show Reviews
Very happy with these bulbs. I now have replaced all in My RV.
I received the lights within about a week. They worked as advertised and I am very happy with them.
Very bright, very white. Only one out of fourteen bulbs faulty. Small power draw.
M4 Note: Contact us regarding replacement of any bad bulb. DOAs are extremely rare. Also, ensure the wires on the bottom of the bulb are aligned properly up and away from the side of the base then reinsert into the socket.
I have a solar set up for my travel trailer with two batteries. I wanted to replace the trailer's original bulbs with these LED bulbs.
Very easy to swap out. Purchased a dozen as I needed 11 bulbs. Nice bright light. Will really help when boon docking.
Replaced the bulbs in the light fixture over the dining table in our motorhome. What a difference! Now we can eat and read in comfort. No more heat bearing down, and much better illumination. I love the fact that we are placing less stress on the batteries.
Could not be happier. Great product - excellent service (returning calls, shipping and advise)
Bought these for the basement of the 5ver .
Takes a few seconds longer to put them in for the first time.
Well worth it.
After applying some dielectric grease i managed to get the bulbs partially in the fixture but every now and then they come loose and i have to put some pressure on them to push them in. Cannot get them to go all the way in
M4 Note: Popping out is not a normal report, I would like to hear more of your fixtures. Original glass bulbs can be thicker or thinner, we tend to stay on the thicker side so that they don't fall out of sockets from being too loose. Once seated though, they should stay, possibly reduce the di-electric grease amount.
Nice and bright at a fair price
The Bulbs are very bright just what I wanted in my vanity area, I had warm white but they just werent bright enough for the dark area. Whit that being said the only problem with the bulbs is the thickness of the base, I used "bulb" grease to get them in the sockets but even then one of them split the plastic socket
M4 Note: Our bases are a standard thickness. Glass bulbs can vary in thickness, so we size in the middle so there they are not loose in fixtures that have had thicker incandescent bulbs in them before. When installing, rock them slightly back and forth (along the length of the tab) and they will install easier. Unfortunately some plastic sockets are brittle from long use of very hot incandescent bulbs.