Now a brighter 24 LED design. This is a very bright RED LED with 24 Samsung 5630 LEDs! A common size for tail lights with a double contact round base and the lights have a low and high light setting for tail and brake lights in one bulb. The 5630 LED is much brighter than a 5050 LED, and the Red Color accentuates your Red Lens to make a very rich bright light.
LED Tail lights come on faster, use less power, generate very little heat, and are brighter.
This is a non-canbus light. Canbus is required on some vehicles if the vehicle computer checks for burned out bulbs, or for turn signals (may cause signal to blink rapidly). Trailer lights do not require Canbus LEDs.
A very bright replacement tail light for trailers or vehicles with Towing Heavy Duty Relays. On vehicles without, it will blink rapidly as if a bulb is out. If you don't know if you have a heavy duty relay, remove one bulb and turn on your turn signal. If the indicator and remaining bulbs blink at the normal rate, you can use this bulb as is, but if it blinks rapidly this is not compatible. A Load Resistor can also be put in the circuit to cure rapid blink problems.
Total Length - 2 1/4"
Length of Head - 1 3/8"
Diameter - 3/4"
Voltage - 12v DC
Not DOT Certified.
14 Reviews Hide Reviews Show Reviews
I bought these LED’s to replace the old bulb type on the back of my coach. Screwed right in and at least 25% brighter in the daylight.
The product was exactly as I was needing. Delivered as promised also.
My sockets on my taillamps are lousy and don't hold the bulb securely against the socket contacts and they keep coming loose and therefore non-functioning. I need to figure something out. When they're on, they are wonderful.
Steve, any ideas?
M4 Note: In most sockets, behind the plate with the contacts is a spring. The spring can become compressed over time. With the light off and the bulb out, use a very small tool to hook and pull up on the plate. Do this on three sizes to pull it up evenly. Also, ensure the contact are clean. If that doesn’t work, replacement sockets are available at the local auto parts store (if compatible with your fixture).
Steve was very helpful on what I needed , light are what I was looking for. The blubs are very good quality! Thanks for your help!!!!
Have to say the first one I received did not work. Replacement works great. Very bright and more visible than standard. Going on a 1964 Chevy Van. One of the final steps to the restoration.
Very satisfied with the LED replacement tail lamps lamps for our Jeep. Significantly brighter and hopefully easier to BE SEEN. These are quality products and customer service is outstanding. Thank you, Steve, for your time, patience and knowledge of products.
My turn indicators are a statement of intention, not a request for permission. I wanted to increase the visibility of my turn indicators. These sure did the trick.
Wanted to improve visibility to others and installed all LED exterior lighting on my RV. I am not disappointed. Excellent product.
These seem great so far and much brighter than my stock trailer lights. Super easy to install too.